26
LOWERING LEVER
（
The operation is the same as the four post lift
）
(2)
0
When pressed, the hydraulic fluid is released from the jack cylinder into the oil reservoir of the
pump to lower the jack under the weight loaded.
Please follow the instruction below if the control panel is equipped
：
Figure 17 – CONTROLS OF LIFT
POWER SWITCH (1)
The power switch can be set in two positions:
0
0 position:
the electric circuit is not powered; the switch can be padlocked toprevent the useof
the lift.
0 1 position:
the electric circuit is powered.
PLIOT LAMP (2)
It shows that the electric circuit is Powered.
LIFTING BUTTON (3)
0 When pressed, the power unit isrunning and the lift can be raised to a desired height until the
button is released.
Jack operation can be summarized into three steps:
Never operate the jacking beam with any person.
Never exceed the rated lifting capacity.
Always ensure that the mechanical safeties are engaged before any attempt is
made to work on or near the vehicle.
8.2.1 LIFTING
Check and keep the rail channel clean of debris and any object that may hinder the movement
of the jacking beam.
Lower the jack fully by depressing the lowering lever.
Adjust the width of the jack lifting arms so that the rubber pads can contact the lifting points of
the vehicle recommended by the vehicle manufacturer.
Raise the jack by depressing the lifting button. Keep an eye on the jack when the rubber pads
contact the vehicle to ensure the proper contact. Adjust the width of the jack lifting arms if
necessary.
8.2.2 STANDING
Stop raising the jack just as vehicle is raised off the lift runways. Confirm the vehicle is stable
and seated properly before lifting the vehicle to the desired height.
After the vehicle is raised to the desired height, lower the jack to the nearest safeties.
