Apeks 2000 PSI Series, Owner'S Manual

Page: 8 / 56

Updated 6/16/2016 Copyright Apeks LLC, 2014
8
1.1.5. The diaphragm compressor is designed to be anchored to the floor in order to keep it
from moving during operation. A forklift is required to lift and remove the diaphragm
compressor off of the pallet and place on the floor. Not removing the diaphragm from
the pallet will void the warranty.
1.1.5.1. The system weighs in excess of 1500-lbs, take extreme caution when lifting or
moving the system. Do not attempt this step without adequate help.
WARNING
The compressor weighs over 1500-lbs (680-kg), use a minimum of three
people to stabilize the system while moving.
2.3.2.2 Before lowering the diaphragm compressor to the floor, install the rubber feet
provided, to the frame. These rubber feet can then be anchored to the floor.
2.3.4 The orientation of the diaphragm compressor should be directly behind the Apeks
system with the stainless steel belt cover facing away from the Apeks system as shown below.
Figure 7. Orientation of the diaphragm compressor and Apeks system.