Updated 6/16/2016
Copyright Apeks LLC, 2014
41
4. Before moving the motor retighten the bolts to finger tight (this keeps the motor from lifting up
on one side during adjusting due to the belt tension).
5. Adjust the set screws on the motor base in or out to tighten or loosen the bolt as necessary.
6.
Be sure to check motor shaft alignment (note: can be up to 1/8” difference from side to side).
7. Retighten motor bolts.
8. Rotate belt by hand around one turn (failure to do so could result in incorrect reading).
9. Check belt tension again and repeat as necessary.
Summary of Contents for 2000 PSI Series
Page 49: ...Updated 6 16 2016 Copyright Apeks LLC 2014 49 ...
Page 50: ...Updated 6 16 2016 Copyright Apeks LLC 2014 50 Appendix C CO2 Phase Diagram ...
Page 51: ...Updated 6 16 2016 Copyright Apeks LLC 2014 51 ...
Page 52: ...Updated 6 16 2016 Copyright Apeks LLC 2014 52 Appendix D Training Process ...