6
6. OPERATING INSTRUCTIONS
1. Outlet opening
2. Mounting foot, rotatable
3. Air inlet
4. Connection cable with 12 V
vehicle connector
6.1 OVERVIEW
Figure 1: Overview
Look for a suitable location in your vehicle to position the
fan heater. The fi xture surface must be smooth and even (no
grained surfaces). Pay attention to the appropriate points in
the safety precautions (section 4). Clean the surface and the
underside of the fi xture pedestal to remove dust and grease.
Pull the protective fi lm from one side of the adhesive strip
(Position 7 in the overview). Place the adhesive strip onto the
fi xture pedestal, with the adhesive surface on the bottom,
Position 7 in the overview) and push fi rmly into place, see
Figure 2.
Now remove the other protective fi lm of the adhesive strip.
Place the fan heater in the cleaned spot in your vehicle and
press fi rmly into place.
6.2 INSTALLATION / FIXTURE
Figure 2: Mounting adhesive strips
6.3 CONNECTING THE FAN HEATER
Verlegen Sie das Anschlusskabel so, dass Sie beim Fahren nicht
behindert werden. Kontrollieren Sie, ob der Schalter (Position
5 in der Übersicht) sich in der Stellung „0“ befi ndet, siehe Bild
3. Insert the plug of the connection cable (position 4 in the
Figure 3: Switch position „0“
Position „0“
Only operate the fan heater when driving or when
the motor is running, otherwise there is a risk that
the battery of your vehicle may be discharged.
Using the switch you can choose between two modes:
You can switch the device off by bringing the switch to the „0“
position.
6.4 OPERATION
7. TROUBLE-SHOOTING
Problem
Possible cause
The solution
The fan
heater
is not
working
The connector has
not been inserted
correctly into the
vehicle socket.
Pull the connector
out of the socket and
insert again.
With some vehicles,
power is only
supplied to the
vehicle socket when
when the ignition
is switched on and/
or the engine is
running.
Switch on the ignition
and start the engine.
The fuse of the
vehicle socket has
blown.
Replace the fuse
belonging to the
vehicle socket.
The fuse in the car
plug has blown.
Replace the fuse
for the car socket.
Section 7.1
Position I: Fan
Position II: Fan with heating
5. Switch
6. Hinge
7. Adhesive strip
overview) into the 12 V vehicle socket. The fan heater is now
ready for operation.