22
5.3.2 Installation type B
FILTER UNIT
Before proceeding with the installation, do the following :
-
remove inlet grill by pressing the black hatches towards the centre
-
remove the filters
-
remove the grills of the outlets, pulling outwards (spring secured)
Blanked holes
a) On the ceiling side panel of the machine there are
four blanked holes. These have been closed with
membrane type cable glands. Cut the membrane in
order to allow passage of the suspension bars.
b) remove the internal plastic blanking plugs that
correspond to the external cable glands. The
suspension bars may exit from the holes about
50mm. Using the nut and washer, secure and level
the machine.
RE OXYGENISING UNIT
In order to install the re oxygenising unit with passing suspension bars (type B), proceed as follows::
-
remove the grills of the outlets, pulling outwards (spring secured)
-
remove the lower inspection panel by unscrewing the 4 fixing screws (just in case of the re oxygenising
unit)
-
cut the membrane covering the top holes
-
enter the suspension bars into the machine, and use the 8x24 washer and nut to secure. Level the
machine.
Re oxygenising unit
Outlet unit
Membrane
covered holes
Outlet grill
Feb
. 12
Automatikprodukter
