AIR QUALITY
MOBILE
50P
Jan 2012
Automatikprodukter
7 . 7
N I G H T - T I M E R E V I T A L I S A T I O N W I T H
E N V I R O N M E N T A L D E O D O R I Z A T I O N
If the Revitalizer is off or in flow position 2 or 3, this phase is activated by pressing button 1 of the infrared
remote control unit three times consecutively, while if the flow is 1, the button should be pressed twice.
During this phase, night revitalisation is signalled by the flashing of the yellow ION-ON and FILTER ON leds,
and must only be used during the period when the premises are not occupied by people.
After this activation it is possible to change the fan speed.
The benefits which can be found with night-time revitalisation are especially evident the following morning
when an air quality at a level never found before will be noted.
Night-time revitalisation must be turned off in the morning by pressing the OFF button on the remote control
unit or turning the display to 0 (zero) by means of the MANUAL button; then activate the daytime operating
phase by turning the Revitalizer to one of the 3 speeds available, by means of the remote control unit or the
MANUAL button.
7 . 8
S I G N A L S
The electronic control of this apparatus provides the user visually with all the information on operation
required for correct use, and makes available the means for fast checking to seek any small anomalies, by
means of the RESET-TEST-ON/OFF FILTER buttons.
7 . 9
S T A T E O F F I L T R A T I O N E F F I C I E N C Y
As described in paragraph CONTROL PANEL, the three Leds of FILTRATION STATUS provide indications
on the state of filtration efficiency.
The environmental revitalisation cycle remains active until optimal air filtration is obtained, indicated by the
FILTER OK or PRE-ALARM Leds. If optimal filtration is not guaranteed, the red Led MAINTENANCE, will go
on and the automatic revitalisation cycle will be deactivated (FILTER ON and/or ION-ON Leds off). In this
case only the electric fan will run.
To turn off the alarm, simply turn off the Revitalizer, turning it to 0 (zero), and then start it again at any one of
the three speeds; if the operating condition with the red MAINTENANCE Led persists, carry out a general
check of the filtering system, see ORDINARY MAINTENANCE.
