（
1
）
Turn on the SW2 switch to set indicator to the Configuration mode.
Display shows “F1”.
（
2
）
Press until display shows “F7” (see Fig. 13.2.1). Press
to go to
F7.1 Menu. Display shows “F7.1”
（
3
）
When display shows “F 7.1”, press
. Display shows the current
consecutive number “nnnnnn”. Edit numbers according to Fig. 4-2.
（
4
）
After editing, press
to return to F7.2 Menu. Display shows “F7.2”
（
5
）
When display shows “F7.2”, press
. Display shows “nnnnnn”. Edit
numbers according to Fig. 4-2.
（
6
）
After editing, press
to return to F7.3 Menu. Display shows “F7.3”.
（
7
）
Turn off the SW2 switch to exit from Calibration mode and enter into
Weighing Mode.
13.5 Date and Time Setting
（
1
）
Follow points (1) and (2) to enter into F7 Menu.
（
2
）
When display shows “F7.1”, press
until display shows “F7.4” (see
Fig. 13.4). Press
to enter into Date setup mode and display shows
“DD.MM.YY”.
date.
（
3
）
When date setup is complete, press
to return to F7.5 Menu.
Display shows “F7.5”.
（
4
）
When display shows “F7.5”, press
and display shows time
“HH.MM.SS”. Follow Fig. 4
-2 to set the current time.
（
5
）
When complete, press
to return to F7.6 Menu. Display shows
“F7.6”.
（
6
）
Turn off the SW2 switch to exit from Calibration mode and enter into
Weighing Mode.
14.
Serial Communication
Indicator has the following two serial communication modes:
o
Continuous transmission
o
Transmission upon request (from an external PC)
46
|
ANYLOAD 805TS & 805BS Series Weighing Indicator Operations Manual (v1703)
