（
2
）
Press until display shows “F8” (see Fig. 13.2.1). Press
to go to
Print output menu and display shows “F8.1”.
（
3
）
When display shows “F8.1”, press
twice and display shows “F8.3”.
（
4
）
When display shows “F8.3”, press
to show “Set?”. There are 2
options then:
Press
to change GFMT and NFMT format characters to
default value in Table 13.
2, and
then return to F8 Menu. Display
shows “F8”.
Press
to give up restored default format operation and to
return to F8 Menu. Display shows “F8”
（
5
）
Turn off the SW2 switch to exit from Calibration mode and enter
into Weighing Mode.
13.4 Print Consecutive Number
Set print consecutive number in Print mode. F7.1 Menu (CONSNU) is the
current consecutive number. The consecutive number value is increased by 1
following each print operation. When start up indicator, F7.2 is assigned as the
initial consecutive number. F7.2 is used to set the initial consecutive number.
Refer to F7.1 Menu and F7.2 Menu for details.
Detailed Setup Procedure:
Fig. 13.4 Consecutive Numbering Setup
45
|
ANYLOAD 805TS & 805BS Series Weighing Indicator Operations Manual (v1703)
