(1)
Turn on the SW2 switch to set indicator to the Configuration mode
(display shows “F1”)
(2)
Press to show “F8” (see Fig. 13.2.1). Press to Print Format
Menu and display shows “F 8.1”.
(3)
When display
shows “F8.1”, press
again and display shows the
first 6 digits of GFMT format.
(4)
Use
，
to move the cursor to different flashing digits. When it is
at the far right position,
press
again, the first digit at the left is
removed and another digit prompts up at the right. When it is at the
far left position, press , the last digit at the right is removed and
another digit prompts up at the left. Press
to add a space to the
left of the flashing digit.
(5)
When the cursor is at a certain digit position, press
to edit.
Display shows the characters as shown in Appendix 15.5. “_.” is
shown for characters not available in Appendix 15.5.
(6)
While editing, use
，
to move between characters. To delete a
character from the string press
. Once deleted the indicator will
return to F8.1.
(7)
When character editing is completed
, press
to return to (4) above
and to perform editing other characters. When finish editing, press
to return to F8.1 and display shows “F8.1”.
(8)
Press to go to F8.2 Menu and display shows “F8.2”. Refer to (3) to
(7) for format editing of NFMT.
(9)
Af
ter finishing, turn off the SW2
switch to exit from Calibration mode
and enter into Weighing Mode.
Note: When inputting characters, display shows characters as per Table 13.2.
“_“ is shown for unavailable characters.
13.3 Default Formatting
（
1
）
Turn on the SW2 switch to set indicator to the Configuration mode
and display shows “F1”.
44
|
ANYLOAD 805TS & 805BS Series Weighing Indicator Operations Manual (v1703)
