27
“Pause at height”
will allow the printing to pause at a specified height, as well as
where the print head would move to and how much filament to retract to prevent
extruded filament blobs. So, customers could do filament change during printing.
“Tweak at Z”
would allow custom changes at specified Z height. Customers may
decide the Z height or layer counts at which to make a change. Then there are more
settings for how you would like to change, such as temperature, fan speed and print
speed. Fine tune those for specific model would produce better results.
If wish to delete the plugins, stay mouse at the edge, hold the left button and drag
mouse to show the Delete.
(Figure 29)
(4) Start/End-GCode
As shown in Fig. 30, custom Gcode allows for complex automatic printer movements
and operations. By adding custom Gcode into the start or end of the Gcode file,
customer could change how it prints. A detailed list of Gcode commands can be found
via:
http://reprap.org/wiki/G-code
There will be explanation later about how to resume from outage by adding command
Stay mouse here and drag
to show the delete button
Delete
