ANTTI Vacboost M13, Installation And Operating Instructions Manual

Page: 27 / 73

Antti-Teollisuus Oy 27 408111 03-2019
Vacboost M13
Installing the upper limit sensor
(Capacitive, adjustable)
The delivery of the dryer machinery includes a capacitive level guard with an adjustable rod.
Install the upper limit sensor in the bracket located in the dryer's top. Install the sensor sufficiently low to prevent the
elevator from congesting during the first times of use. The correct height of the sensor is about 60 cm from the top.
Follow the dryer's filling rate during the first filling and drying rounds. You must search out the correct height for
the upper limit sensor, because in practice, it varies. Observe that the grain mass expands in the beginning of the
drying phase. Therefore, some space must be reserved for the pre-cleaner. Fix the height position of the sensor
using the wing screw.
Over time, the sensor's head may get dirty and start transmitting wrong data. Due to the above reason, the sensor
head should be cleaned from time to time.
Installing the elevator
Assemble the elevator base at the side of the frame, and bring it upright. The standard A-model elevators for the
mobile dryer are delivered ready-assembled.
An elevator that differs from the standard configuration, shall be assembled according to the instructions 408010
or 408011.
NOTE! An elevator, that lies on the ground, must not be lifted only by its centre point, but by two points that are
sufficiently far apart.
Lift the elevator into place, and as required, adjust the height of its base after having attached the conversion part
to the elevator.
The assembly instructions for the service platforms and the support of the ES and EHS type elevators are included
in the instructions for the E-series elevator 408010.
Large bolt-assembled hopper
Assembly in accordance with the instructions 408110.
The intake pit with Skandia conveyor
To be assembled in accordance with the instructions 408115.