ANTTI Vacboost M13, Installation And Operating Instructions Manual

Page: 36 / 73

Antti-Teollisuus Oy 36 408111 03-2019
Vacboost M13
Fuel pipes
The mobile dryer has a single-pipe fuel system, so there is no need to route more than one pipe from the fuel tank
to the fuel filter located at the side of the heater. The "excess" fuel, returning from the burner, recirculates to the
burner, and additionally, the required fuel flows through the filter to the Tigerloop.
Installing the debris piping for the pre-cleaner
NOTE! The debris piping must always be routed to the opposite side of the dryer to the inlet air open-
ing of the dryer heater.
Debris in the inlet air of the dryer heater is a fire hazard!
Route down the debris piping for the pre-cleaner on the side of the dryer.
Install the debris piping using the parts intended for this purpose: The ventilation pipes D200 and the elbows of
45 and 90 degrees. Support the piping at every 3–4 metres using, for example, perforated steel band.
It pays to route the debris pipe of the pre-cleaner to a cyclone (option) that separates the dust and debris from the
air. This helps keep the surroundings of the dryer clean and tidy.
The dust cyclones can be purchased from Antti-Teollisuus