ANTTI Vacboost M13, Installation And Operating Instructions Manual

Page: 41 / 73

Antti-Teollisuus Oy 41 408111 03-2019
Vacboost M13
1.3 Installing the temperature sen-
sors
Pull the PTC sensor (1) with its conductors (4)
through the nylon pipe (2) so that the metal part
of the sensor will stick out about 20 mm from
the nylon pipe.
Drill a hole of 10.5 mm in the air pipe, and install
in it the lead-through gasket (3).
Push the nylon pipe with the sensor through the
lead-through gasket into the air pipe, about 50
mm of the nylon pipe will be left out.
SEE THE DRAWING ON PAGE 8
1.4 Installing the upper limit sensor
Upper limit
Drill a hole of 45 mm in the top of the dryer or the storage silo, and install in it
the holder for the sensor pipe (2).
Push the sensor pipe (3) into the grain space so that the feeler (4) comes at the
desired height of the upper limit. Lock the sensor pipe in position by tightening
the locking bolt (3).
Connect the upper limit sensor to the system in the connecting box (1) in ac-
cordance with the wiring diagram.