ANTTI Vacboost M13, Installation And Operating Instructions Manual

Page: 45 / 73

Antti-Teollisuus Oy 45 408111 03-2019
Vacboost M13
3.1.2 Operating switch for the elevator
The elevator is controlled by means of a 1 – 0 – 2 switch (8).
Position 0
The elevator is switched off
Position 1
The elevator is running continuously. During the drying phase, the switch
must stand in the position 1. Then the elevator will run irrespective of the
upper limit sensor's state.
Position 2
Once the surface of the grain reaches the upper limit sensor of the dryer,
the elevator will stop. During filling phase, the switch may stand in the posi -
tion 2. Then the elevator and the feeder will stop as soon as the upper limit
switch is reached.
3.1.3 Operating switches for other appliances
The feeder, the pre-cleaner, the bottom screw and the burner are controlled by means of the 0 - 1 switch (9, 10,
11 and 13).
Stipulations:
- The elevator and the bottom screw must be running before the feeder can be started.
- The blower must be running and the safety devices must not be blocking the operation before the burner
can be started.
Position 0
The appliance is switched off
Position 1
The appliance is switched on, provided that the stipulations below are being
met.