Antec Signature S10, User Manual

Page: 18 / 184

18 S10 User Manual rev 1C
The unique and innovative Three Chamber Design of the S10 allows air flow for each chamber to be individually
controlled
,
achieving maximum balance between performance and quiet computing. There are total of 7 fans pre-
installed (plus one optional mount) inside the case.
4.1 Top Exhaust Fans / Radiator – Motherboard Chamber
There are 2 x 140 mm fans preinstalled on the top of the Motherboard Chamber to exhaust heat generated from the
motherboard quietly and efficiently, especially from the CPU.
1. Open the side panel.
2. The fan bracket is held by two thumbscrews right under the top panel (figure 31). 2x 140 mm fans are
pre-installed in the bracket.
3. Loosen the thumbscrews to remove the fan bracket from the upper housing (figure 32).
Note: Disconnect the fan power connector before removing the fan bracket.
4. You can service the fans as you wish now (figure 33).
Note: This bracket is also compatible with 2 x 120 mm fans.
5. Reinstall the fan bracket back to the location. Make sure to align the three tabs with the holes inside the
case and reinstall the thumbscrews.
Rated Voltage: DC 12V
Operating Voltage: 7.0V – 13.2 V
Speed Start Voltage Input Current Air Flow Static Pressure Acoustic Noise Input Power
800 RPM 7V 0.12A (Max) 41.2 CFM
0.28mm- H
2
O
(0.011 inch-H
2
O)
14 dBA 1.4 W (Max)
For 280 mm / 240 mm Radiator Installation:
This bracket is compatible with 280 mm or 240 mm radiators for water cooling. Follow the original instructions
from the water cooling system to install the radiator to the fan bracket.
Figure 31 Figure 32 Figure 33