Antec Signature S10, User Manual

Page: 12 / 184

12 S10 User Manual rev 1C
2.5 Removing / Replacing Air Filters
Central Intake Air Filter
1. The filter is located in the Air Intake on the side of the Motherboard Chamber.
2. While facing the left side of the case, pull the lower tab down by grabbing the top portion of the tab as
shown in figure 11 and figure 12.
3. You will see another tab at the bottom of the filter. Pull this tab and slide the filter out of the Central Air
Intake (figure 13).
4. After cleaning and drying the filter, slide the filter back into place and close the tab.
Power Supply Intake Air Filter
1. The filter is located at the bottom of the power supply.
2. Slide the filter toward the rear of the case to remove (figure 14).
3. Clean and dry the filter, then slide the filter into place.
Hard Disk Drive Intake Air Filter
1. While facing the left side of the case, open the side panel as shown in
Section 2.1, Figure 4 .
2. The filter is located inside the Hard Disk Drive Chamber just above the top hard drive rails (figure 15).
3. Slide out the filter as shown. Clean and dry the filter, then slide the filter back into place.
Figure 13
Figure 12 Figure 11
Figure 15
Figure 14