Antaeus AT 75 B, Operation Manual, Page: 35 / 53

Chapter 6. Operation specifications
6.1.1 Preparation before operation
1.
Check whether the vibrator has been installed on the
vice arm arm as required.
2. Check whether the hose s are damaged and whether
there is any visual oil leakage.
3. Check whether the controller switch is okay and whether
the wire harness is exposed.
4. Check whether the lubricating oil of all parts is normal
and whether the lubricating oil of gear box is normal.
5. The controller power switch can now be turned to "on".
6. Test whether the vibration controller is normal.
7. Test whether the clamp controller is normal.
8. Test whether the rotation controller is normal.
9. Test whether the second vibration controller is normal.
10. No load test ≤ 5 minutes
6.1.2 Vibration
operation
1. Start the engine and increase the throttle slowly.
2.
Press the indicator light of the excavator to check whether
the excavator operates normally.
3.
When
pressing
the foot pedal, the machine will vibrate with
the first stage power. When the vibration motor accelerates, the
vibration of the pile driver will increase accordingly, and the
vibration frequency will be increased to about 2800 ~ 3200 /
minute.
4. Press walking pedal, "the second section of vibration
confluence switch is on", and then step down
on the
pedal, at
this time, the vibration frequency of the pile driver will increase,
and the vibration frequency will rise to about 2800~3200
vibration times / minute
P33