Antaeus AT 75 B, Operation Manual, Page: 30 / 53

5.2.2 Precautions
1.
High frequency hydraulic vibratory pile driver
s
should be carried by
the certified and skilled driver.
2. The starting of the pile driver should be sped up from low gear to
high gear.
3. Pay close attention to the indication of current and voltage on the
control box while working, in case of any abnormality, the machine shall
be stopped immediately for inspection.
4. Free loading test should not surpass 5 min utes
5. While working please install the pile with safety wire in advance.
6. When the hydraulic hoses breaks, please stop work immediately,
adjust the pile to prevent it from falling over or dropping , and turn off the
engine of the hydraulic excavator.
7.
When driving or pulling piles, please do not exceed the maximum
clamp load of the pile driver, which may damage the elastomer and
cause the pile driver to slip off the pile . (please note the maximum clamp
load of pile driver used)
8. Never force driving or pulling.
9. Please do not stand under the pile driver except for the operation of
connecting piles.
10. When the pile driver is running, be sure to clamp the tooth block
tightly. And confirm that the hydraulic system is running normally.
11. Impact driving (vibrating with the clamps open) will damage the
equipment.
12. When clamping the pile, there should not be any space between the
jaws and the pile.
P28