Anritsu 3656C W1, User Manual, Page: 116 / 164

4-4 W1 Verification Application Installation Using the PVS Software with the ME7828A
4-2 PN: 10410-00784 Rev. A 3656C W1 Cal/Ver Kit & 2300-616-R PVS UG
4-4 W1 Verification Application Installation
Prior to installation of the W1 Application the National Instruments GPIB card and drivers must be installed
in the Windows PC.
This only needs to be done once per PC Controller. The software is contained on the
Disk supplied with each
Verification Kit.
1. Turn off all other running applications on the PC Controller.
2. Insert the USB Memory Device into the USB slot.
3. Open
Windows Explorer
, browse to the USB Drive, and double click on
Startup.htm.
4. On the navigation page, click the
Install Anritsu 1.0 mm Verification Application Software
link.
5. The first of several installation dialog boxes appears.
6. Click
Run
on the two security dialog boxes ( Figure 4-2 on page 4-3 ).
Note
In order to correctly install the PVS application, the logged in user must have Administrative rights on
the Windows PC Controller.
The PVS application is installed onto the PC Controller on an all-user basis.
If your organization does not allow for all-user installations, consult your internal PC and network
support group on how to best proceed.
Figure 4-1. PVS Installation and Documentation Screen
Note The dialog box appearance may vary depending on the Operating System being used.