5
8. Error and information messages
DMX address blinks
It means that no DMX signal is received. Check DMX connectors and cables, check connection between the
fixture and the control desk.
Note of exclamation at sign "Art"
It means that no ArtNet signal is received. Check RJ 45 connectors and cables, check connection between the
fixture and the control desk.
Tilt Err
This message will appear after the reset of the fixture if the head´s magnetic-indexing circuit malfunctions (sen
-
sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not
located in the default position after the reset.
Pan Err
This message will appear after the reset of the fixture if the head´s magnetic-indexing circuit malfunctions (sen
-
sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not
located in the default position after the reset.
Focus Err
T
his message will appear after the reset of the fixture if the focus module malfunctions (sensor failed or magnet
is missing) or the stepping motor is defective or its driving IC on the PCB.
Temp Err
T
his message informs you that head temperature exceeded 70°C and light source has been switched off.
InnCom Err
This message informs you that communication between
Raspberry and a pan/tilt PCB is faulty.
Ethernet Err
T
his message informs you that some ethernet error has occured e.g. faulty network card.
Need Hw Upd
T
his message informs you that hardware update has to be performed.
Clear air Filt.
T
his message informs that the menu item remaining time ("R Ti ") in the menu "Information" is at 0 value. Clean
air filter and reset this counter.
Summary of Contents for MiniMe
Page 1: ...Version 1 6...
Page 28: ...28 Dimensions mm Mounting bracket optional...
Page 30: ...30...
