Anolis MiniMe, User Manual

Page: 19 / 41

9
environment.
It is therefore impossible to specify accurate cleaning interval. This item allows
you to change the cleaning interval of the air filters. This "alert" value is 300 hours and it
is set as default. Inspect the fixture within its 300 hours of operation to see whether cleaning
is necessary. If cleaning is required, clean all air filters and change the value in this menu
on acceptable level. Min. level of alert period is 10 hours, max. is 300 hours.
R Ti
-
Remaining Time
.The item allows you to read the time which remains to cleaning
air filters.The time period is set in the menu mentioned above.
Expired time period is signalled by a negative mark (-) at the time value and a warning
message on the display.
Clean the air filter and reset the counter by pressing the [Enter] button twice.
DMX In - DMX readout. The menu is used to read DMX values of each channel received by the fixture.
Temp - Temperature . The menu shows temperatures in the fixture.
Current - A current temperature in the fixture head and CPU.
Highest - A maximum temperature in the fixture head and CPU since the fixture has
been fabricated.
High Res - A maximum temperature in the fixture head and CPU since the counter
was last reset.
In order to reset this counter, press and hold both [NEXT] and [PREV] buttons
and the [Enter] button at the same time.
Sw Ver
-
Software versions
. Select this item to read the software version of the fixture modules.
GE
- A graphic engine
IC-1
- A pan/tilt and zoom module
5.3 Personality (Pers)
Pan Rev - Pan reverse . The item allows to invert pan movement.
Tilt Rev - Tilt reverse . The item allows to invert tilt movement.
P/T Mode
-
Pan and Tilt movement mode
. Use this menu to set mode of the pan/tilt movement.
Speed
- Both Pan and tilt will move with the same speed as adjusted at the channel 5
"Pan/Tilt speed, Pan/Tilt time".
Time
– The pan and tilt will move with different speeds and they will come at
the same time to the end point of their tracks (pan and tilt use their optimal speeds).
Time of the pan/tilt movement (25.5 sec. max.) is set by the channel "Pan/Tilt speed, Pan/Tilt
time".
P/T Feed - Pan & Tilt Feedback . The menu item allows to return the mowing head to the required pan/tilt
position after changing the position by an external force if this option is set on.
Note. The Pan/Tilt Feedback should be permanent On, the option Off is not suitable for standard operation and
the head of the fixture can be damaged!
BLC DMC - Blackout during movement correction . Set this option on if you wish to close light
output during the time when the head goes to its correct position, which has been changed by an
external force.
Act Blc
-
Active blackout
. Use this menu if you wish to close the light output during effect changes.
P/T Mov
- The menu item allows to close light output while the pan/tilt coordinates
are changing.
C Cal M - Colour calibration mode . The function switches on/off the colour calibration mode. If the function
is active, a white colour (0-15 DMX) at the channel " Virtual colour Wheel" is set to 8000K.
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function turns the display by 180°. The display can be also turned by pressing
and holding the [ESCAPE] button.
On/Off T - This function allows you to keep the display permanent on or turn it off
two minutes after last pressing any button on the control panel.
Contrast
- Use this function to adjust contrast of the display (0-15).
Backlight
- Use this function to adjust backlight of the display (0-15).