000-015-480 Issue 5
22
nd
May 2017
Anite S-CORE Getting Started Guide
Page 40 of 47
Commercial In Confidence
6.4
Limitations for multicell RF stack
Currently, it is limitation in RF multicell stack that both cells should be turned on together at the
same time. For multicell test-cases, it has been mentioned in the specification to turn off the cell 1
and turn it on later in the test case. For this, cell RF power is reduced to very minimum value and
will be increased when required in the test case to turn on the cell.
Also, cell settings which are exported using single cell RF stack cannot be imported directly for cell
settings in multicell RF stack. They need to be updated manually.
6.5
RF connection for multicell test cases
Connect both RF output (1A and 1B) from front panel of S-CORE to UE while running Multicell test
cases.
6.6
Configuring S-CORE GUI for single cell
If you have installed the Multi-cell RF stack package (as described in 6.2), you can also use the S-
CORE in a single cell configuration as described below.
1.
Depending on the RF technoloy required, on the left-hand menu of the S-CORE GUI, right-click
on the cells that are not required, select
Technology
and select the
NONE
option for the RAT
as shown below:
2.
Repeat for all cells except for the one that is required for testing.
For Multi-cell test cases, RF
ports 1A and 1B (labelled 11
and 12) need to be connected
to the UE