Angioscan Electronics AngioScan-01, User Manual, Page: 14 / 119

10
© 2014 AngioScan-Electronics LLC
AngioScan Software Installation
2.1 USB Driver Installation
The driver will be installed automatically during the AngioScan software installation. In case of error,
window of driver's installer will remain on screen.
AngioScan device can be connected or disconnected from computer. It is preferable to connect the
device to computer after software and driver installation, as in this case "Found New Hardware" dialogue
will not appear. If the device is connected before software installation, the "Found New Hardware"
dialogue will appear. Close the dialogue without performing any action.
It might take some time (several seconds) to connect USB device after driver installation so that the
system could initialize device's parameters. During that time the device will not operate.
If the driver is already installed, the system will check its version. If the installed driver has later version
than the being installed one, the system will not perform any action. Otherwise the installed driver will be
updated.
Usually, the system restart is not needed after driver installation. However, in case it is needed to restart
the system,
the corresponding messages will show up.
Driver installer is available after software installation as well: there is an icon "USB Device Driver
Installer" in AngioScan folder. If the problems occur during driver installation, this installer will help to
manage them.