ANEP S-BOX
Version N° 3
11/06/2014
38
5 - ProgrAMMing MoDe
important :
• Access to the programming mode is only possible if the phone line is hung up.
( Beware if several modules share the same line )
• The
S-BoX
keypad is used to program all the parameters.
• To avoid unwanted modifications, the programming mode is protected by an access
code :
*
1 2 3
• This code may be modified by the technician ( 1 to 7 digits )( see page 15 )
5.1 - enter programming mode
Enter
*
followed by the access code to enter programming mode
Example : using the factory default code
*
1 2 3
the unit plays a melody
... Then 2 beeps are made every 20 seconds
5.1.1 - exit programming mode
when the unit has been programmed
Press the key «
*
»
Finish programming, the unit plays a melody
note
: If no key is pressed for over 3 minutes, the unit will automatically exit the
programming mode.
the unit play's a melody
