Anderson SMARTMIX A1230FD, Operator'S Manual

Page: 53 / 129

Anderson Group Mixer – Operator's Manual 51
To connect the hydraulic and electrical systems:
1. Connect the hydraulic hoses.
l
With the SMART Control option, follow the hoses to the nose and follow the IN and OUT
markings to ensure that everything is connected correctly.
l
For direct drive, see the following table:
Function Identification
Close the hatch 1 yellow cable tie
Open the hatch 2 yellow cable ties
Disengage the restrictor blades 1 red cable tie
Engage the restrictor blades 2 red cable ties
Turn the conveyor to the right +/in
Turn the conveyor to the left -/out
Offset the conveyor to the right 1 blue cable tie
Offset the conveyor to the left 2 blue cable ties
2. Ensure that the hydraulic hoses will not get tangled or stuck between the tractor and mixer,
which causes premature wear and tear.
3. Connect the 12-V power cable for the mixer's computer and electrical/hydraulic controls.
4. Plug the rear lights into the 7-pin socket on the tractor.
5. Check that the tractor and machine turn signals correspond to one another.
If the mixer does not have a SMART Control remote, the hydraulic and electrical connections are
done. If the mixer has a SMART Control remote and the tractor has a closed-centre hydraulic
system, see the following sections.
3.2.1 Additional connections for tractors with a closed-centre hydraulic system, a
mixer without a conveyor, and a SMART Control remote
1. Remove the hood covering the nose of your SMARTMIX.
2. Remove the oil recirculation valve and its electrical connector (see Figure 12-1).
3. Attach the electrical connector with the other connectors in the nose.
4. Put the cover (see Figure 13-A) on the oil valve (see Figure 12-1).
5. Disconnect the hydraulic hose (see Figure 12-2).
Since the hydraulic system is full of oil, keep rags
and a container handy to collect the oil when you
disconnect the hydraulic hose.
6. Put the plug (see Figure 13-C) in the hydraulic hose (see Figure 12-2).