Anderson SMARTMIX A1230FD, Operator'S Manual

Page: 66 / 129

64 Operator's Manual – Mixer Anderson Group
4.3 Adjusting the cut size
As a safety precaution, always switch off the
hydraulic system before proceeding.
The cut size depends on the position of the two hydraulic restrictor blades. The restrictor blades are
controlled by a hydraulic cylinder that moves them in and out of the mixing chamber. You can adjust
the cut size by limiting the stroke of the hydraulic cylinder. For a finer cut, the restrictor blades must
be completely inside the mixing chamber (see Figure 23-A).
1. Using the hydraulic controls or the optional SMART Control remote, move the restrictor blades
all the way out of the mixing chamber (see Figure 23-B).
2. Stop the tractor.
3. Remove the restrictor blade guards on each side of the machine by unscrewing the four (4)
bolts on each guard.
4. Insert the stroke limiter bolt in the hole that corresponds to the desired position (see Figure
24).
5. Put the guards back on.
Figure 23 — Restrictor Blades In (A) Restrictor Blades Out (B)