Installation Guide
For Andersen® 1000 Handle Set and Closer
READ ENTIRE GUIDE BEFORE BEGINNING INSTALLATION. Please handle your components with care to avoid damage and/or scratches.
pLEASE NOTE: Proper assembly, installation and maintenance are essential if the benefits of your Andersen
®
product are to be fully attained. Therefore,
please read and follow this guide completely. If your abilities do not match this procedure’s requirements, contact an experienced contractor.
You may direct any questions to the Solution Center at 1-800-933-3626, Monday through Friday, 7 a.m. to 7 p.m. Central Time, and Saturday
and Sunday, 8 a.m. to 5 p.m. Central Time.
IMpORTANT
w a r n i n g
Improper use of hand or power tools could result in injury and/or product damage. Follow equipment manufacturer’s instruc-
tions for safe operation. Always wear safety glasses.
RECOMMENDED TOOLS
• Safety Glasses
• Phillips Head Screwdriver
• Hammer
• Pencil
• 3/32” & 5/32” Drill Bits
• Drill
• Chisel
• Center Punch
EMCO Enterprises, Inc.
PO Box 853
Des Moines, IA 50306-0853
Revised 04-2007 7057
Part Number 616316
EMCO Enterprises, Inc. is a wholly owned subsidiary of Andersen Corporation. EMCO manufactures Andersen® and EMCO®
doors. EMCO supports the limited warranties covering Andersen® storm and screen doors. “Andersen”, “EMCO” and all other
marks where denoted are trademarks of Andersen Corporation. ©2007 Andersen Corporation. All rights reserved.
FASTENER IDENTIFICATION
#6 X 0.8”
PHiLLiPS Pan HEaD SCrEw
QTY: 2
#6 X 1/2”
PHiLLiPS FLaT HEaD SCrEw
SELF-TaPPing
QTY: 4
#10 X 1-1/2”
PHiLLiPS FLaT HEaD SCrEw
QTY: 1
#8 X 1/2”
PHiLLiPS FLaT HEaD SCrEw
QTY: 2
#12 X 5/8”
PHiLLiPS Pan HEaD SCrEw
QTY: 2
SHOrT Pin
QTY: 1
LOng Pin
QTY: 1
#10 X 2”
PHiLLiPS Pan HEaD SCrEw
QTY: 4
