Preconfiguring the NXA-WAP1000
17
NXA-WAP1000 Smart Wireless Access Point
Troubleshooting Installation
If the startup sequence does not work, verify that the network name (SSID) and security settings (if you
enabled them) on the AP match the settings on your wireless device.
Disconnect the AP from the power source, wait 5 seconds, reconnect it, and then wait 60 seconds
before attempting a reconnection.
Disconnect and reconnect the AP and the PC.
Replace the Ethernet cable with a new one if the relevant LAN port LED is not illuminated. (LEDs
in each port light up during a successful connection.)
If all else fails, you can reset the AP to the factory defaults (and start over). Press and hold the Hard
Reset button (FIG. 2) for at least eight (8) seconds.
You can now reconnect your computer directly to the AP and then start over with installation, using the default
network settings.