Browser-Based Configuration Pages
27
NXA-WAP1000 Smart Wireless Access Point
Configuration
The Configuration section contains pages for initial configuration of the NXA-WAP1000. For more
information on initial configuration, please refer to the
Preconfiguring the NXA-WAP1000
section on page 8.
Device
Changing the Administrative Login Settings
The default user name is
admin
and the default password is
1988
. To prevent unauthorized users from logging
in to the Browser-Based Configuration Pages using these default administrator login settings, changing the
default Web interface password immediately after your first login is highly recommended.
To change the default administrator login settings:
1.
Go to
Configuration > Device
. The
Device
page appears.
2.
Under
Service Provider Login
, change the default administrator login settings.
If the NXA-WAP1000 is already configured, or if it is being managed by an
NXA-WAPZD1000 ZoneDirector, this section will not be visible in the Browser-Based
Configuration Pages. This section will be accessible again only if the device is reset
to its factory defaults.
FIG. 14
Configuration - Device page
Configuration - Device
Device Name:
Type a new name for the device or leave as is to accept the default device
name (amxAP). The device name identifies the AP among other devices on the
network.
Device Locations:
Type the address or location where the device is deployed.
GPS Coordinates:
Type the latitudinal and longitudinal coordinates of the device location.
Service Provider Login:
Username:
Type the name that you want to use for logging into the Browser-Based
Configuration Pages. The default user name is
admin
.
Current Password:
Type the current administrative password. The default administrative password
is
1988
.
New Password:
Type the new password that you want to use. The password must consist of six
to 32 alphanumeric characters only.
Confirm New Password:
Retype the new password to confirm.
Update Settings:
Click this button to save and apply your changes.