Drill 4 holes of Ø6mm (Ø0.25”Inch) on wall. Press fit
plastic anchor and assembly fastener. Leave 5mm to
6mm gap between wall and fastener head.
Use the four mounting slots given on the back of the
radio to mount to the wall.
Introduction
This guide provides quick installation steps for cnPilot E501S
Access Points (APs).
Tool Requirements
• Phillips screwdriver (Wall Mounting)
• Flat head screwdriver (Pole Mounting)
• 12 mm wrench
(Pole Mounting)
community.cambiumnetworks.com
JOIN THE CONVERSATION
Package Contents
Pole mounting bracket
PoE Injector
Cable gland
(Qty. 2)
E501S Access Point
Align Radio to required angle by tilting up and down.
The maximum radio tilting angle is ± 40°, with an
incremental of 10°.
Radio holder
Hose clamp
(Qty. 2)
Power Cord
Tools Required
Wall mounting kit
(Qty. 4)
M12 x 60 Bolt
M12 Nut & Washer
STEP
1
(Pole Mount)
Assemble the radio holder to the pole mounting bracket
and secure it with M8 nuts by applying 3.0 Nm torque.
STEP
2
(Pole Mount)
Insert hose clamps through pole mounting bracket and
clamp to pole by applying 3.0 Nm torque.
STEP
3
(Pole Mount)
Align the radio chassis with the guide rails of radio
holder and slide it downwards until it clicks into place.
Cable gland components
Components
Gland Assembly
Cable gland assembly sequence
Cap Plastic Seal Body
6. Assembled cable gland.
5. Assemble cap and body.
4. Insert seal into body.
3. Insert seal into the plastic.
2. Put seal over the cable.
1. Pass cable through cap.
STEP
4
STEP
5
(Pole Mount)
Insert RJ45 to radio housing and the lock cable gland to
radio housing with 1.5Nm to 2Nm torque.
For suggested Lightning Protection Deployment visit
http://bit.ly/cnPilot_Lightning
STEP
6
(Radio alignment)
Wall Mounting
802.11ac Outdoor WLAN Access Point with Integrated
90°/120° Antenna & IP67 Industrial Grade Gigabit WiFi
cn
Pilot
™
e
501S
90/120° Sector
108
100
Quick Start
Guide
Model:
cnPilot
e501S
