Configuring Communication
62
10" Modero Touch Panels
12.
Verify the fields in the
IP Settings
section have been properly configured. Refer to
Step 1: Configure the
Panel’s Wireless IP Settings
section on page 57 for detailed information.
13.
Press the
Back
button to return to the Protected Setup page and press the on-screen
Reboot
button to both
save any changes and restart the panel.
Remember that you will need to navigate to the System Settings
page and configure the connection to a target Master.
14.
After the panel restarts, return to the Wireless Settings page’s RF Link Info section and verify the Link
Quality and Signal Strength:
The descriptions are:
None
,
Poor
,
Fair
,
Good
,
Very Good
, and
Excellent
(FIG. 64).
Configuring the Modero’s wireless card for secured access to a WAP200G
After logging into the WAP200G, the default Status page appears within the web browser. These
read-only values are "pulled" from some of the other user-configurable Configuration Utility pages. By
default, wireless Modero panels are configured for unsecured communication to a Wireless Access Point. To
properly setup both the WAP200G and panel for secure communication, you must first prepare the Modero
panel and then use the information provided to fill out the fields within the WAP’s browser-based Basic
Wireless Configuration page.
Since the code key generator on Modero panels use the same key generation formula, all panels will generate
identical keys for the same Passphrase. The generators used on WAPs will not produce the same key as the
Modero generator even if you use the same Passphrase.
For this reason, we recommend FIRST creating the
Current Key on the Modero and then entering that information into the appropriate NXA-WAP200G
fields
.
1.
Provide power to the panel (this allows it to detect the internal wireless card).
2.
Press the
Protected Setup
button (located on the lower-left of the panel page) to open the Protected Setup
page and display an on-screen keypad.
3.
Enter
1988
into the Keypad’s password field and press
Done
when finished.
4.
Press the
Wireless Settings
button (located on the lower-left) to open the Wireless Settings page.
5.
Locate the Wireless Security section (FIG. 65).
FIG. 64
Wireless Settings page - Open (Clear Text) security method
Required Information:
SSID (Network Name used by the Target WAP)
By default, this field displays the SSID -
AMX
The signal strength field should provide some descriptive text regarding the strength
of the connection to a Wireless Access Point. If there is no signal or no IP Address
displayed; configuration of your network could be required.
Summary of Contents for modero NXD-CV10
