![background image](http://html1.mh-extra.com/html/amx/hdmi-utpro-0808/hdmi-utpro-0808_instruction-manual_2938469035.webp)
Installation and Setup
35
Instruction Manual – HDMI-UTPRO-0808
To connect an HDMI UTPro to a LAN:
1.
Complete the installation of the HDMI UTPro including power up of the system.
2.
Insert one end of the RJ-45 link cable into the LAN 10/100 port on the enclosure.
3.
Connect the other end of the RJ-45 link cable to a LAN hub or switch. The network will automatically assign a
DHCP IP address (the assigned IP address can then be changed to a static IP address, see page 75). If the LAN does
not utilize DHCP, see the “Workaround” below.
4.
Check the indicator LEDs for the LAN 10/100 connector (see
5.
Determine the IP address by accessing Zero-Config information NetLinx Studio WebConsole (see below). Make
note of the IP address to use in the test procedure at the top of page 36. NetLinx start up takes approximately
3 minutes.
6.
Complete the installation by testing the connection (see the instructions on page 36).
Note:
The LAN 10/100 port can also be used to Telnet into the HDMI UTPro to determine its MAC Address
(see page 131).
Workaround for Networks that Do Not Utilize DHCP
If the network does
not
utilize DHCP, you
must
connect either to a standalone router that supports DHCP or to a PC that
is running DHCP emulation software. Once the router or PC assigns a DHCP IP address, that IP address is used to access
the WebConsole from which you
must
then change the DHCP IP address to the static address provided by your Network
Administrator before you connect the HDMI UTPro directly to the LAN.
Determining IP address for HDMI UTPro
The HDMI UTPro features a built-in zero-configuration networking client that allows you to determine the unit’s
IP address for the HDMI UTPro WebConsole via Bonjour for Windows
®
or a similar zero-configuration client.
Zero-configuration (or zeroconf, also known as “Bonjour”) technology provides a general method to discover services
on a local area network. In essence, it allows you to set up a network without any configuration.
To determine the DHCP IP address that the network assigned to the HDMI UTPro in Step 3 of the previous instructions,
you can access the unit via NetLinx Studio.
NetLinx Studio version 3.0 (or higher) features a “Zero-Config” tab in the Workspace window. This tab provides
Zero-Config networking functionality within NetLinx Studio.
Note:
Refer to the NetLinx Studio online help for details on using Zero-Config.
The following assumes that the WebConsole connection (LAN 10/100 port) is to the same LAN as the PC running
NetLinx Studio and the NetLinx Master for the HDMI UTPro.
To determine the IP address by accessing the HDMI UTPro via Zero-Config:
1.
In NetLinx Studio (v3.0 or higher), left-click the Zero-Config tab on the Workspace Bar to open the tab.
FIG. 20
NetLinx Studio showing the Zero-Config tab and the IP address for an HDMI UTPro
Zero-Config tab
IP address for HDMI UTPro
HDMI UTPro