![background image](http://html1.mh-extra.com/html/amx/hdmi-utpro-0808/hdmi-utpro-0808_instruction-manual_2938469031.webp)
Installation and Setup
31
Instruction Manual – HDMI-UTPRO-0808
Important:
Before attaching source and destination devices, we recommend reading the “Setting Up HDMI
Systems” chapter for information on concerns and considerations you should be aware of when switching
HDMI (see page 60).
Important:
UTP cable quality required in order to meet 100 meter distance should meet
ANSI/TIA/EIA 568A-5 or better specification and be rated for 250 MHz or better.
To attach cables for switching/transport:
1.
Attach an HDMI cable from the first source device to the first HDMI matrix switching input connector.
2.
Attach one end of an HDMI patch cable (provided) to the first HDMI output connector.
3.
Attach the other end of the HDMI patch cable to the first HDMI transport input connector.
4.
Repeat Steps 1 through 3 for the remaining source devices; be sure each patch cable is connected to corresponding
numbers (2 to 2, 3 to 3, etc.). The number for the HDMI matrix switching output connector and number for the
HDMI transport input connector
must
match for each patch cable.
5.
Attach a UTP cable to the first UTP (RJ-45) transport output connector.
6.
Attach the other end of the UTP cables to the RJ-45 input connector on the first HDMI-UTPRO-RX Receiver.
For mounting information for the Receivers, see page 15.
7.
Repeat Steps 5 and 6 for the remaining Receivers.
8.
Connect the HDMI-UTPRO-RX Receivers to the destination devices using HDMI cables.
FIG. 14
Cables connected for switching/transport from the first source to the first destination device
HDMI matrix switching output
UTP (RJ-45) transport output
HDMI matrix switching input
HDMI transport input
HDMI-UTPRO-RX
Source device
Destination device
HDMI cable
HDMI cable
UTP cable up to 100 m (328 ft.)
HDMI patch cable