AMX endeleo UDM 1604, User Manual, Page: 40 / 94

4-4
UDM1604-USG – 2.0 - 0606
Section 4
Protocols and IR Learning
Figure 4-3: Creating a new Infrared protocol (table)
(4) The hub prompts for the relevant action which is to be
performed e.g. vol up. Select the relevant action from
the
Action drop down menu eg vol up.
Figure 4-4: Creating a new action for an Infrared protocol
Warning!
Ensure the device’s remote control is pointing to the IR
sensor located at the front of the UDM Hub when
performing key presses. If not the key presses may
not be stored in the UDM Hub.
(5) Click on Step 1 . A message saying Press key on
remote will appear. Click the relevant key on the
device’s remote control which will manage the action
vol up.
Figure 4-5: Configuring the device’s remote Step 1
(6) Click on Step 2 . A message saying Press key on
remote will appear. Click the same key on the device’s
remote control which will manage the action vol up.
Figure 4-6: Configuring the device’s remote Step 2
Note;
The IR learning process requires that the command on
the device’s remote is learned twice i.e the same
remote control command needs to be repeated at step
2.