![background image](http://html1.mh-extra.com/html/amx/dxlink-hdmi-mmf-d/dxlink-hdmi-mmf-d_instruction-manual_2939353099.webp)
Appendix B – Telnet (Terminal) Commands
99
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Telnet Commands (continued)
GET DNS
Gets the list of DNS entries.
Example:
>get dns
DNS Servers
-------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
Note:
When the DXLink Fiber unit is in DHCP Mode, these are active values, NOT the stored
values that only apply to Static IP Mode.
GET ETHERNET
MODE
Note:
This command applies only to the Receiver.
Displays the current LAN configuration setting.
Settings are
either
“auto” in which the LAN driver will discover its settings based on the
network it is connected to
or
<speed> and <duplex> where speed is either 10 or 100 and
duplex is either half or full (10 half, 10 full, 100 half, 100 full).
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
Note:
See SET ETHERNET MODE on page 102.
GET FRIENDLY
<name>
Displays the device’s friendly name (for NDP).
GET IP
Displays the IP configuration of a device.
The device displays its D:P:S, Host Name, Type (
DHCP
or
Static
), IP Address, Subnet Mask,
Gateway IP, and MAC Address.
Example:
>GET IP
HostName DXLF-TX
Type DHCP
IP Address 192.168.44.86
Subnet Mask 255.255.255.0
Gateway IP 192.168.44.2
MAC Address 00:0f:3c:00:55:04
(
also displays “Lease” details; see example for GET CONFIG command
)
GET LOCATION
Displays the location parameter for NDP, which is set by using the
SET LOCATION
command
(see page 103).
GET PULSE TIME
Displays the current pulse time in milliseconds.
Example:
>get pulse time Pulse Time is now: 500
GET SN
Returns the device’s serial number.
GET SYSTEM
NUMBER
Displays the stored system number.
Example:
>get system number
System Number
------------------------------------------
Stored Value: 0 (preferred for auto mode)
Active Value: 1 (connected NDP)