![background image](http://html1.mh-extra.com/html/amx/dxlink-hdmi-mmf-d/dxlink-hdmi-mmf-d_instruction-manual_2939353104.webp)
Appendix B – Telnet (Terminal) Commands
104
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Telnet Commands (continued)
SET TELNET
PASSWORD
Note:
This command is supported but is not presently in the Help file list of commands.
Sets the username for a secure Telnet session.
• Default = blank (no password required)
• For details, see page 94
SHOW ANALOG
STATS
Note:
This command applies only to the Transmitter.
Displays information about the analog signal.
Example:
>show analog stats
Detected Timing: 1920x1080p @ 60.0 Hz
Format: VGA
Scan Type: PROGRESSIVE
Sync Type: SEPARATE
H Sync Active: YES
V Sync Active: YES
H Sync Polarity: POSITIVE
V Sync Polarity: POSITIVE
Block Length: 3191
Field Length: 1757
Lines/Vsync: 5
Lines/Field: 1125
SHOW CONNECTION
STATS
Shows the connection statistics for the device.
Output similar to the following example:
>show connection stats
Connection Statistics
Total Last 15 Minutes
===== ===============
ICSP Messages: 10039 received 333 received
10038 transmitted 333 transmitted
Blink Messages: 5014 received 166 received
IP Statistics:
RX packets:29298 errors:0 discarded:0
TX packets:15286 errors:0 discarded:0
SHOW DECODER
DUMPS
Note:
This command applies only to the Transmitter.
Displays decoder register information.
Example (partial due to length of decoder dump):
>show decoder dumps
ADV7623 IO Registers (8-bit address 0xb2):
00 01 02 03 04 05 06 07 : 08 09 0a 0b 0c 0d 0e 0f
---------------------------------------------------------------
00 -0a 05 f2 00 62 2c a0 40 : 14 00 90 44 42 1e 0f 1e
10 -00 00 c9 0d 6a a0 43 5a : 34 00 02 00 00 00 00 20
20 -ff 00 00 03 00 00 00 00 : 00 00 00 00 00 00 00 00
30 -88 00 00 00 00 00 00 00 : 00 00 00 00 00 00 00 00
40 -20 30 14 00 00 00 10 00 : 00 00 00 00 00 00 00 00
50 -00 00 00 00 00 00 00 00 : 00 00 00 0a 00 00 00 0c
60 -03 00 00 00 fd 4c 00 00 : 00 f9 44 00 00 00 ff 07
SHOW DECODER
STATS
Note:
This command applies only to the Transmitter.
Displays decoder information.