![background image](http://html1.mh-extra.com/html/amx/dxlink-hdmi-mmf-d/dxlink-hdmi-mmf-d_instruction-manual_2939353102.webp)
Appendix B – Telnet (Terminal) Commands
102
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Telnet Commands (continued)
SET DEVICE
Sets the device number, and stores it in non-volatile memory.
Syntax:
SET DEVICE <num>
The valid range of device numbers is 0 to 31999.
• If the user enters a number outside that range, then no change will be made and the
DXLink Fiber unit will issue an error message.
• A Device Number of ‘0’ means that the DXLink Fiber unit will accept the auto-assigned
device number from the Master.
• If the new device number is different from the old device number, the DXLink Fiber unit will
disconnect from the Master, and begin trying to connect with the new settings.
Note:
These changes do not require a reboot to take effect.
SET DNS
Sets the DNS configuration of the DXLink Fiber unit, only as applied to Static IP Mode
(DNS settings in DHCP Mode are received from the DHCP server).
Syntax:
SET DNS
This command prompts you to enter a Domain Name, DNS IP #1, DNS IP #2, and DNS IP #3.
• Enter Y (yes) to approve/store the information in the Master.
• Enter N (no) cancels the operation.
Note:
The device must be rebooted to enable new settings.
Example:
>SET DNS
-- Enter New Values or just hit Enter to keep current settings --
Enter Domain Suffix: amx.com
Enter DNS Entry 1 : 192.168.20.5
Enter DNS Entry 2 : 12.18.110.8
Enter DNS Entry 3 : 12.18.110.7
You have entered: Domain Name: amx.com
DNS Entry 1: 192.168.20.5
DNS Entry 2: 12.18.110.8
DNS Entry 3: 12.18.110.7
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable new settings
SET ETHERNET MODE Note:
This command applies only to the Receiver.
This command sets the current LAN configuration settings per new mode.
Syntax:
SET ETHERNET MODE <m>
Values for
<m> (mode)
are:
auto, 100 full, 100 half, 10 full, 10 half
Note:
This command requires a reboot to enable new settings.
Examples:
set ethernet mode auto
set ethernet mode 100 full
Note:
See GET ETHERNET MODE on page 99.
SET FRIENDLY
Set the device’s friendly name for NDP to <name>.
Syntax:
SET FRIENDLY <name>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be
truncated.
• The value is stored in non-volatile memory.
• If no value specified, an automatic name consisting of AMX, the product name, and serial
number will be used.
Note:
This command requires a reboot to enable new settings.