![background image](http://html1.mh-extra.com/html/amx/dxlink-hdmi-mmf-d/dxlink-hdmi-mmf-d_instruction-manual_2939353052.webp)
Installation and Setup
52
Instruction Manual – DXLink Fiber™ Transmitters and Receivers, Duplex
Detailed NetLinx (Link/Act and Status) LED Behavior
The tables below provide detailed descriptions of all blink patterns for the NetLinx Link/Act and Status LEDs on the
front of the Transmitter and Receiver units.
Note:
The term “light show” refers to the back-and-forth scanning pattern of the LEDs associated with the
LEDs on the DXLink Transmitter and Receiver.
DXLink Fiber TX/RX Operational State as Indicated by LEDs
To determine the operational state (normal boot) of a DXLink Fiber Transmitter or Receiver by its LEDs, check both the
Link/Act and Status LED columns.
ID Pushbutton Boot State and LED Behavior
To monitor the ID Pushbutton boot state of a DXLink Fiber Transmitter or Receiver by its LEDs, check both the
Link/Act and Status LED columns.
NetLinx LED Behavior and Operational State
Link/Act LED
Status LED
DXLink Fiber TX/RX Operational State
ON when connected to the
switcher (which contains an
integrated Master).
Blink OFF with data.
Follow Master’s instruction for Blink Message
if online with Master, otherwise ON.
Normal Online with Master (rest)
OFF
ON
Normal Boot (DHCP found)
Note:
This state continues from the time
an IP address is obtained until the device
is online with the Master.
Fast blink, then normal
operation.
ON
Normal Boot (DHCP, no server)
Note:
This state continues until a valid
IP address is obtained.
OFF during light show, then
normal operation (OFF until
connected to Master).
Fast blink (continues only during light show),
then ON until first blink from Master.
Normal Boot (Static IP)
Note:
This state continues until the
device finishes its light show.
ID Pushbutton Boot and NetLinx LED Behavior
ID Pushbutton Boot States
Link/Act LED
Status LED
Boot with ID Pushbutton held
down.
Slow blink (1 Hz)
Slow blink (1 Hz)
ID Pushbutton held down long
enough for reset to default
parameters.
Fast blink until ID Pushbutton is released,
then OFF
Fast blink until ID Pushbutton is
released, then OFF
ID Pushbutton held down long
enough for reset to default
firmware image.
Solid ON, transitions to OFF once the unit
completes writing to flash and is ready to
reboot.
Solid ON, transitions to OFF once the
unit completes writing to flash and is
ready to reboot.
In Auto ID mode.
Normal
Blink (2 Hz)
ID Pushbutton held down long
enough to accept new ID.
2 blinks, then normal
2 blinks, then normal
After boot: ID Pushbutton held
down, but not long enough for
IP mode change.
Slow blink (1 Hz)
Slow blink (1 Hz)
After boot: ID Pushbutton held
down long enough for IP
mode change.
Fast blink, then OFF
Fast blink, then OFF