RGBHV+Stereo to CatPro Input/Output Boards
143
Optima Instruction Manual
Attaching Cables & Wires (RX Module)
Important:
To guarantee 1,000 ft. (305 m) skew compensation, the inter-pair skew must equal
<20 ns/ 100 m. Pre-installed cables should be tested for skew. Cables will work if they test less than
62 ns skew and are within 1,000 ft. (305 m).
CatPro Supported Cables
CAT-5
CAT-5e
CAT-6
CAT-6e
STP (Shielded Twisted-Pair)
Note:
Skew-free cable is not recommended for use with AMX AutoPatch equipment.
To attach cables and wires to the CatPro RX Module:
1.
Insert the HD-15 connector (FIG. 113) into the Video Out connector.
2.
Wire the audio connector (FIG. 113).
3.
Insert the RJ-45 connector into the UTP/STP In receptacle.
4.
Plug the power cord into the power jack and into the power source.
Note:
For adjustment procedures when CatPro RGBHV+Stereo RX Modules are used in
conjunction with Optima CatPro input/output boards, see page 139.
RX HD-15 Video Out Pinout
FIG. 113
CatPro RX Module connectors and audio wiring
FIG. 114
Pinout for CatPro RX Module HD-15 connector
Power
RJ-45
Audio
HD-15
Unbalanced audio
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
RX Module HD-15 Connector Pinout
Output
1. Red
6. Red GND
11. ID Bit
2. Green
7. Green GND
12. ID Bit
3. Blue
8. Blue GND
13. Horizontal sync
4. ID Bit
9. +5 VDC out DDC 14. Vertical sync
5. GND-N/C
10. Ground
15. ID Bit
Note
:
55 mA supplied on output pin 9;
power draw not to exceed 50 mA per port
.
Summary of Contents for AutoPatch Optima AVS-OP-1616-110
