APWeb Expansion Board
149
Optima Instruction Manual
Cabling & Applying Power
After installing the APWeb board, connect it to a LAN or a Network Interface Card (NIC) in a PC.
During the initial setup (see below), the APWeb board discovers the system. After the initial setup, it
does not need to rediscover the system (even if power is cycled). If connecting to a PC, the PC’s settings
may need to be changed (contact your Network Administrator).
Cable Requirements
LAN Connection – Use an RJ-45 straight-through patch cable.
PC Connection (NIC Card) – Use an RJ-45 crossover cable.
Connecting to a LAN or a PC
Important
:
AMX AutoPatch systems should only be linked in their own isolated networks.
To connect the APWeb board to the LAN or PC:
1.
Complete the installation of the Optima enclosure(s) according to the installation procedure in the
“Installation & Setup” chapter (page 17).
Do not apply power until Step 4 below
.
2.
Insert one end of the RJ-45 cable into an active LAN connection or a NIC.
3.
Insert the other end of the cable into the TCP/IP (RJ-45) jack on the APWeb board (FIG. 119).
4.
Apply power to the Optima enclosure(s). Apply power to the attached source and destination
devices last.
5.
Check the indicator LEDs (see page 146).
6.
Allow 20 to 60 seconds for discovery, then test the connection (see page 150).
FIG. 119
Fasten the Ethernet link connector
Ethernet Link Connector
Cable from active LAN
Summary of Contents for AutoPatch Optima AVS-OP-1616-110
