Installing Acendo Vibe
12
Acendo Vibe Conferencing Soundbars - User Guide
ACV-2100 Connectors
The connectors on the ACV-2100 are shown in FIG. 12: .
Run each cable through the cable pass-thru in the bracket/door and under the cable strap.
Rotating the Acendo Vibe Into the Seated Position
After connecting all cables, close the Bracket to return the Acendo Vibe to its seated position. The Bracket is secured via
internal magnets (FIG. 13):
FIG. 12
ACV-2100 connector bay
ACV-2100 Connections
DC POWER
Connect the included 15V
power supply to this barrel connector. Only use the power supply included with
the ACV-2100.
OPTICAL AUDIO:
Use this TOSLINK connector to receive Optical Stereo Input from an audio source device.
AUX OUT
Use this 1/8” mini-stereo connector to send analog stereo sound from the ACV-2100 to an auxiliary device.
AUX IN
Use this 1/8” mini-stereo connector to receive analog stereo sound from an analog audio source device.
USB
Use the USB 2.0 Type-B port to connect a PC/laptop to the ACV-2100 as a source device.
Acendo Vibe is plug-and-play with PC/laptop using a standard UAC driver.
The USB connection is also used to configure the ACV-2100 via the AMX Acendo Vibe configuration
application and for file transfers.
RS-232
3-pin captive-wire connector provides serial communication with the Acendo Vibe. Refer to the Serial
Commands section on page 31 for command definitions.
The Baud Rate for the RS-232 connector is 115200.
FIG. 13
Rotating the Acendo Vibe into its seated position
Analog audio input
Analog audio output
Optical audio input
DC Power input
USB (Type B)
cable strap
cable strap
RS-232 (3-pin captive wire)
Rotate the Acendo Vibe into seated position
(Bracket is secured with magnets)
front
open
closed
