AMSAN AM-WB10810A, Manual

Page: 12 / 28

4.1.8.
．
After finishing clipping the counterweights, put down the guard or press (when no hood)
，
to
perform balancing spin again, if comes out 00 00
，
means balancing succeed. (Fig.5)
Fig. 5
4.2.
ALU-1 mode (ALU-1, ALU2 same operation, only the position to add weights differently)
4.2.1. Set “a” “d” “b” values
4.2.2. Press until ALU1 indicator lit up
4.2.3. Put down the guard or press (when no hood)to perform a measuring spin.
4.2.4. In a few seconds, the wheel is brought to operating speed and begin measuring unbalance, the unbalance values
remain on instruments 1 and 4 when the wheel stopped. Press may check the real unbalance value under the threshold.
4.2.5. Anticlockwise moving wheel slowly, the displays with right LED’s lit up full indicate the correct angular position
where to mount the counterweights, 12 o’clock position outside, as Fig.6, add the counterweight.
Fig. 6
4.2.6. Anticlockwise moving wheel slowly, the displays with left LED’s lit up full indicate the correct angular position
where to mount the counterweights, 12 o’clock position inside, as Fig.7, add the counterweight.
Fig. 7
4.2.7. After finishing mounting the counterweights, put down the guard or press (when no hood)
，
to
perform balancing spin again, if comes out 00 00
，
means balancing succeed. (Fig.8)