AMSAN AM-WB10810A, Manual

Page: 11 / 28

AM-WB10810A
0. (The value measured in automatic mode appears on the display). Or press and to set
manually.
●
set “b” value
：
set nominal diameter “b” marked on the wheel or use the width gauge to measure
the value of ”b” as Fig.2, then press and
●
set “d” value
：
this value measured in automatic mode same time as “a” value set, or press and
to set manually.
Fig.1 Fig.2
4.1.4. Put down the guard or press (when no hood)to perform a measuring spin.
4.1.5. In a few seconds, the wheel is brought to operating speed and begin measuring unbalance, the unbalance values
remain on instruments 1 and 4 when the wheel stopped. Press may check the real unbalance value under the threshold.
4.1.6. Anticlockwise moving wheel slowly, until the right LED lit up full, clip weight on 12 o’clock position (Fig.3)
Fig. 3
4.1.7.
Anticlockwise moving wheel slowly, until the left LED lit up full, clip weight on 12 o’clock position (Fig.4)
Fig. 4