Chapter 2
Installing ReadyBoard 800 Options
24
QuickStart Guide
ReadyBoard 800
6. Lower the MiniModule ISA board onto the ReadyBoard 800 connector while matching
connectors.
7. Slowly work the connectors together to prevent bending any of the pins.
8. Install the screws (4) through the MiniModule ISA board into the standoffs (4) to secure it to the
ReadyBoard 800 as shown in Figure 2-7.
♦
If you are installing another PC/104 module onto the MiniModule ISA board, use four
0.6" (15 mm) standoffs instead of screws to separate the two boards.
NOTE
The 0.8" (20 mm) and 0.6" (15 mm) standoffs provided by
Ampro are threaded for M3 P0.5 screws (Metric 3, 0.5 pitch).
♦
If you are installing another PC/104 module onto the MiniModule ISA board, refer to the
PC/104 module’s installation instructions before continuing.
9. Reconnect any cables you disconnected earlier and verify all other connections to the
ReadyBoard 800 are still connected.
10. Plug the ATX power supply’s power cord into the AC power source and restore power.
Removing the MiniModule ISA Board
This procedure describes how to remove the MiniModule ISA board from the ReadyBoard 800. You
will typically have other PC/104 modules installed onto the MiniModule ISA board while it is connected
to the ReadyBoard 800. You will typically separate and remove those board(s) in the same manner as
you would with MiniModule ISA board.
1. Remove the four screws (or standoffs) holding the MiniModule ISA board to the ReadyBoard 800.
See Figure 2-7.
2. Lift up slightly at the first corner of the module as shown in Figure 2-8.
This corner was chosen because of the corner’s proximity to the PCI-104 connector.
MM
IS
A
_03b
1st Corner
2nd Corner
3rd Corner
4th Corner
MiniModule ISA Board
Figure 2-8. Removing the MiniModule ISA Board
3. Lift up slightly at the second corner of the module as shown in Figure 2-8.
4. Lift up slightly at the third corner of the module as shown in Figure 2-8.
5. Lift up slightly at the fourth corner of the module as shown in Figure 2-8.
6. Repeat Steps 2-5, until you have removed the MiniModule ISA board from the ReadyBoard 800.
7. Handle the MiniModule ISA board by its edges and place it on an anti-static mat until your are
ready to re-install the MiniModule ISA board.
