Chapter 2
Installing ReadyBoard 800 Options
ReadyBoard 800
QuickStart Guide
19
R
B
800R
Q
K
S
_06a
Keyed Slot (2)
Lip or
Catch Edge
Pin-1 Marker
Compact Flash Socket (J23)
ReadyBoard 800
(Bottom view)
Figure 2-4. Installing the Compact Flash Card
8. Push the compact flash card into the socket until it is firmly into the socket and mates with the
pins. See Figures 2-4 and 2-5.
9. Turn the ReadyBoard 800 back over onto the bottom of the board, placing it on the work surface.
10. Reconnect any cables you disconnected earlier and verify all other connections to the
ReadyBoard 800 are still connected.
11. Set the Master/Slave jumper (JP3) to the correct master/salve state before continuing. See Table
2-1 and Figure 1-4.
12. Set the CF Voltage jumper (JP7) to the correct voltage for the compact flash before continuing.
See Table 2-1 and Figure 1-4.
Table 2-1. Compact Flash Jumper Setting
Jumper #
Installed
Removed
JP3 – CF Master/Slave
Master (pins 1-2)
Slave (removed)
Default
JP7 – CF Voltage Select
3.3V (pins 1-2)
Default
5V (pins 2-3)
13. Plug the ATX power supply’s power cord into the AC power source and restore power.
14. Go into the BIOS Setup Utility and change the settings for the compact flash card placing it in the
Drive Assignment and the Boot Order.
NOTE
The compact flash must be listed in Drive Assignment and the Boot
Order to be recognized by the BIOS. The compact flash can be listed
in any of the drive positions.
However, the BIOS does not support a break in the drive order, that is,
Drive C can not be listed as [none] when the boot device is Drive D.
