Chapter 2
Installing ReadyBoard 800 Options
ReadyBoard 800
QuickStart Guide
15
NOTE
If you remove the SODIMM and restore power without a SODIMM installed,
you will not see a display and your system will not work properly.
R
B
800R
Q
K
S
_05a
DDR SODIMM Socket (J22)
Retaining Latches
DDR SODIMM
45 Angle
°
ReadyBoard 800
(Bottom view)
Figure 2-2. Removing SODIMM from Socket
Installing the SODIMM
If you want to install a larger size SODIMM or replace the existing SODIMM, refer to the following
procedure.
1. Prepare the ReadyBoard 800 for SODIMM installation:
♦
If the ReadyBoard 800 is already prepared for SODIMM installation, with the power turned
off, the power cord disconnected, and an empty SODIMM socket, skip to Step 4.
♦
If the ReadyBoard 800 is operating, power down the system and continue with next step.
CAUTION
To prevent damage to the ReadyBoard 800 and the SODIMM, ensure the power
switch on the power supply is turned off and the power cord has been removed from
the power source. The typical AT power supply will continue to provide standby
current to the board until the power cord is disconnected.
2. Disconnect the ATX power supply’s power cord from the AC power source.
CAUTION
To prevent damage to the SODIMM, do not touch the SODIMM until you have
discharged yourself and followed good Electrostatic Discharge principals. The
SODIMMs are sensitive to static electricity and can be easily damaged by
improper handling. Do the following when handling a SODIMM:
Use an anti-static wrist/ankle strap and a grounding mat connected to ground.
Leave the SODIMM in the anti-static bag until you are ready to install it.
Before you remove a SODIMM from the anti-static bag, touch a grounded,
unpainted metal surface to discharge any static electricity.
3. Disconnect any cables that would prevent you from turning the ReadyBoard 800 over exposing
the bottom of the board.
