Chapter 1
Setting Up the ReadyBoard 800
6
QuickStart Guide
ReadyBoard 800
Skip any of the following steps that do not apply to your situation.
6) Connect the Audio In/Out
Cable Assembly
•
Connect the Audio In/Out cable assembly to J4 near the edge of the
ReadyBoard 800 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
NOTE
The headphone connector in the cable assembly is not
connected at the J4 connector on the ReadyBoard 800.
7) Connect the ATX Power
Adapter Cable Assembly
•
Connect the ATX power adapter cable assembly to J1 and J2 on the
edge of the ReadyBoard 800 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
The ATX power adapter was separated for non-ATX power
supplies and provides a separate power on/standby connector (J1)
from the power input voltage (J2).
∗
If you do not use an ATX power supply, you will have to provide
the standby voltage (+5V) to J1 for the soft off function.
R
B
800R
Q
k
S
_08a
Note: The PS/2 Keyboard/Mouse
connector is shown removed
for clarity.
Connect the ATX Power Adapter
Cable Assembly to J1 and J2
Audio In/
Out (J4)
Power In
(J2)
Power-On (J1)
Connect the Audio In/Out
Cable Assembly to J4
Figure 1-5. Connecting Audio In/Out and ATX Power Adapter Cable Assemblies
NOTE
The ReadyBoard 800 re5V on pin-1 of J1 to operate properly.
Failure to connect both ATX power supply connections or 5V
to pin-1 of J1 will prevent your ReadyBoard 800 from powering on.
Refer to Table 1-2 for more information.
