Chapter 1
Setting Up the ReadyBoard 800
ReadyBoard 800
QuickStart Guide
7
8) Connect USB 2 & 3 Cable
Assembly
•
Connect the USB 2 & 3 cable assembly to J13 on the edge of the
ReadyBoard 800 as shown in Figure 1-6.
Refer also to Figures 1-1, 1-4.
9) Connect Utility Cable
Assembly
•
Connect the Utility cable assembly to J12 near the edge of the
ReadyBoard 800 as shown in Figure 1-6.
Refer also to Figures 1-1 and 1-4.
♦
The green Power-On switch uses Pins-1 & -2 of the Utility
Connector.
♦
The red Reset switch uses Pins-2 and -3 of the Utility Connector.
NOTE
The Power-On switch turns the ReadyBoard 800 to an On condition,
if your are using an ATX power supply. Normally, the operating
system (OS) will turn Off the ReadyBoard during the OS shutdown
process. However, if you need to turn off the ReadyBoard, pressing
and holding the Power-On button for more than 4-6 seconds will turn
the ReadyBoard 800 to an Off state.
For information concerning power management and “sleep states”
under the ACPI standard, refer to the topic
Power and Sleep States
in
the
ReadyBoard 800 Reference Manua
l
.
R
B
800R
Q
k
S
_09a
Connect USB 2 & 3
Cable Assembly to J13
Connect Utility Cable
Assembly to J12
Note: Reset Switch, LEDs, and capacitors
shown removed for clarity.
Figure 1-6. Connecting the Utility and USB Cable Assemblies
