Ampetronic d series, Installation And User Manual

Page: 28 / 48

Ampetronic D Series Installation Handbook & User Guide Page 26
9. EMAIL NOTIFICATIONS
The driver can be configured to send Emails to a specified address under certain conditions.
These Emails contain a list of any errors that are present and the settings of the driver at the time
that the Email was sent . A sample Email is shown below:
“ This is an automatically generated notification Email sent to the contact address
configured by the installer/administrator of an Ampetronic Loop Driver. Please do not reply
to this Email .
Your DXX-X Hearing Loop Driver named XXXXXXXXX with MAC address
XXXX:XXXX:XXXX has either developed a fault or the settings have been modified without
authorisation . The driver or loop may require attention .
The configuration page of the driver can be reached by clicking this link: [Name of driver] if
you are on the same network domain as the driver
The system errors present on the driver when this Email was sent are listed below:
------------------------------------
1). Heatsink too Hot - Derated
2). Heatsink too Hot - Muted
------------------------------------
The current settings of the driver are listed below:
Input 1 level is -80 .0dB
Input 1 mode is Line
Input 2 level is -80 .0dB
Input 2 mode is Line
Current level is -20 .0dB
Current B offset is -1 .6dB
MLC selected is Custom Setting
MLC custom slope 1 is 1 .0dB/Oct
MLC change frequency 1000 .0Hz
MLC custom slope 2 is 1 .0dB/Oct
The measure loop parameters on channel A are 99999mR and 99999uH
The measure loop parameters on channel B are 99999mR and 99999uH
The driver has been running for 0 days, 0 hours, 0 minutes and 30 seconds since it last
rebooted
End of Email”
The Email can be sent when the driver is restarted, when an error occurs or periodically to monitor
the state of the loop driver . These settings are controlled only through the web interface – there
is no menu on the front panel that alters these settings . The controls for the Email system can be
found on the Config tab of the web interface. See section 8 Ethernet interface of this manual for
further information .