Ampetronic d series, Installation And User Manual, Page: 27 / 48

Ampetronic D Series Installation Handbook & User Guide Page 25
Status Tab
The status config tab
allows you to see the
status of the driver .
Firmware: The version of the firmware in the driver and the version of
the website . These two numbers must be the same or the driver
interface may not function correctly. In order to update firmware,
please refer to Section 13 .
Temperature: This is the temperature of the driver’s internal heatsink . If it
exceeds 75°C the driver current will be reduced. If it exceeds 85°C
the driver will be muted .
Transformer Current: The current being drawn from the transformer . If this exceeds
the maximum limit for longer than a defined time then the driver
current will be reduced . The amount of additional attenuation will
be shown in the de-rate section .
De-rate Attenuation: This is the amount of additional attenuation that is added to the
current setting when the transformer is overloaded or the heatsink
is too hot .
Loop A Parameters: The measured value of the resistance and inductance of loop A
when the driver was last restarted or switched on .
Loop B Parameters: The measured value of the resistance and inductance of loop B
when the driver was last restarted or switched on .
Master/Slave Status: This displays whether the driver is operating as a Master or a
Slave .
Up Time: - This shows the time since the driver was last restarted or
switched on .
Start-up Tests: - This shows if the driver has stopped on a start-up test failure
(the test that failed will be displayed in red) or if the start-up tests
all passed (start-up tests completed).
Error: Either No Error if the driver is running correctly or a list of the error
messages in red . See chapter 10 Troubleshooting for a complete
description of the error codes, what causes them and how to fix the
system to remove them .
Compression
Current A
Current B
D14-2 (Departure Lounge)
Settings Settings Driver Config
Software Version
Firmware V 1.00 Webpage V 1.00
Temperature
Heatsink 56 ˚C
Transformer Protection
Current Amps 0.8 A Derate Attenuation 0 dB
Loop A Parameters
Inductance 172 uH Resistance 0.604 Ω
Loop B Parameters
Inductance 0 µH Resistance 0.000 Ω
Master / Slave
Status Master
Up Time
0 Days 1 Hours 10 Min 18 Sec
Start Up Tests
Test Startup Tests Completed
Error
Copyright Ampetronic © 2015